From wes@page.ca Mon Sep 28 05:38:08 2015
Subject:Re: Cap for ROLAND V-Combo VR-09

I'm not confident that hot melt glue would be safe here. You cannot have
any squeeze out, and the gluing force will be really strong given the
shape, high surface area, material, and clearance. I'd be afraid of
damaging either the sliders or the PCB trying to get the knobs off. I'd be
more likely to use contact cement, applied on the shaft in a drop 1mm in
diameter if I was going to glue them.......but I found that just making
sure they were pushed all the way on seems to be enough.

Wes