From goffmac747@aol.com Fri Mar 14 16:55:32 2014
Subject:Re: NORD HALFMOON

Bruce, thanks for the important info. yeah a 3 pos switch even on a real hammond rig, uses the stop position as a duplicate for chorale not unless you have a tie-in into the brake circuit on the leslie amp or use an EIS solid state relay which gives the ability to create brake or coast from a 3 pos switch.

g/

-----Original Message-----
From: Bruce Wahler
To: CloneWheel
Sent: Sat, Mar 15, 2014 4:37 am
Subject: Re: [CWSG] NORD HALFMOON






Goff,

The Nord halfmoon and the CU-1 use the same wiring, which is also the same as that used by the Ventilator (I). It's based on the later Hamm-Suz wiring style:

Tip -> Sleeve (GND) = Chorale
Ring -> Sleeve = Tremolo

The one thing to be aware of: The Nord halfmoon does NOT work as a 3-speed control on the Electro or Stage -- any model that I'm aware of. Early Nord products only accepted a sustain pedal type of switch to toggle the speed. Later models will accept a 2-wire latched input to change Chorale/Tremolo only. So, one could use a CU-1, Nord halfmoon, or the Ashby Solutions Gigger Halfmoon to control two speeds on an Electro 3 or Stage 2 -- with proper menu settings -- but the Off position would not work 'as advertised'; it would duplicate the Chorale setting.

Regards,

-BW

Bruce Wahler
Ashby Solutions.com™
bw@ashbysolutions.com
http://music.ashbysolutions.com
877.55.ASHBY (877.552.7429)


On 3/13/2014 11:42 PM, Goff wrote:







i searched the archives.