From zakemo@AOL.com Fri May 06 19:17:51 2011
Subject:Re: Tubes are THE thing

Not sure what you're asking. If this helps, I had a pedal for my left foot
that would control the speed of the top rotor from stop to fast and
anything in between, (An old Farfisa volume pedal). The bottom rotor was
stationary. Both miked to the Acoustics. One mike each. The pitch bend if I'm
guessing what you heard in the crow song was turning the Hammond off and on
again. Never knew how it was going to turn out rhythm-wise each time but isn't
that we called it, Rock and Roll? (As in the dice). ORF Bob

In a message dated 5/6/2011 6:08:46 P.M. Pacific Daylight Time, goffma
c747@aol.com writes:

How'd you get that slicing top
rotor tone on your rig? And the pitch bend?

[Non-text portions of this message have been removed]