From osmangioia@yahoo.com Sun Oct 17 15:02:46 2010
Subject:Re: Best Vibrato/Chorus scanner emulation on a clonewheel....

The XK3c has 2 keyboard contact busses, one is not touch sensitive (for the organ) and the other sensitive contacts works only for midi out and the internal percussion, if you switch the velocity sensitive percussion mode in the percussion page: KBD - VEL on (When you change this from off to on, you note that now the percussion is velocity sensitive and the percussion note on is a little deeper than before, it acts after the organ note on).

You can put the internal sounds to be switched by the sensitive contacts (The note on becomes a little deeper than the original buss) but the organ don´t respond to velocity information.

For this you must turn on the xk3c while holding the three leslie switches.

In order to come back to the factory settings you must perform the turn on with 3 leslie switches again or perform an all reset to the factory settings.

Osman

--- In CloneWheel@yahoogroups.com, "Carol" wrote:
>