From jpgxk3@yahoo.com Fri Aug 27 14:21:08 2010
Subject:venting

Hey guys, just passing this along as an FYI. I have had nothing but great times with my Ventilator; be it my XK3C, NE2, and now C2. The only issue for me was gotta watch the input signals; specifically the XK3C had to hover @ 1:00 master volume otherwise the red led overload would light up. Not an issue with the NE2, or C2 yet for that matter. Also corresponded with Pablo from NORD assistance; he is against using the headphone output jack of the C2. Oh well.  Of course YMMV, but whatever gets it done.

Joey GB3 NY

Hello Joe,

thanks for your compliments.







The high level out are 14V RMS high
level, unbalanced, and are only intended to be used, directly connected
to a rotary speaker cabinet with built in amplifier.









The C2 manual says it: don't use this output with anything other than a
Leslie. For line inputs (like on the Ventilator) this signal is way too
hot!

Using the left or right output of the organ should be fine.

Regards, Guido

______________________

Neo Instruments
Guido Kirsch
Flemingstrasse 20-22
36041 Fulda
++49 (0)661 9619805
www.neo-instruments.de
gk@neo-instruments.de



[Non-text portions of this message have been removed]