From sven.wannas@multi.fi Thu Jun 18 14:04:48 2009
Subject:RE: xk3c direct help

goffmac747,

There is no direct pin conversion from 11 to 6, you need to put some thing
in between to convert.

Regards,
Sven

-----Original Message-----
From: CloneWheel@yahoogroups.com [mailto:CloneWheel@yahoogroups.com] On
Behalf Of goffmac747@aol.com
Subject: Re: [CWSG] xk3c direct help

Would there be a schematic that shows the pin to pin conversion from 11 to
6?

-----Original Message-----

From: jpgxk3 <jpgxk3@yahoo.com>

To: CloneWheel@yahoogroups.com

Sent: Thu, Jun 18, 2009 7:27 am

Subject: [CWSG] xk3c direct help

Found this old post while searching "1147". Sven, could you contact me
direct to discuss further? I'm interested in this mod. Thanks, Joey G.

"As you said you are no tech but I do want to mention another way also.

I have rebuilt my 142 and 251 Leslies to 11-pin standard and solid state

speed switching. So I plug my 11-pin cable from XK-3 directly into the

Leslie. The XK-3 do have a very strong signal on the 11-pin output so
there

is no need for a preamp in between XK-3 and the Leslie. This type of setup

sounds best to me.

But as always YMMV and you sure going to get a lot of opinions.

Hope this helps a little."

Best regards,

Sven