From lydays@yahoo.com Fri Apr 03 03:27:29 2009
Subject:Re: Speakeasy AMA


>
> --- In CloneWheel@yahoogroups.com, David Jacques wrote:
> >
> > Run your XK3 into the AMA really hot. Then on the power amp side bring
> > the level down and the power amp up for growl and volume....
> >
> > On Apr 2, 2009, at 2:18 PM, michar911s wrote:
> >
> > > Just purchased a Speakeasy AMA and looking for advice. My rig is a
> > > Hammond XK3 into the AMA into a Leslie 303c. The 303xc is a circa'90
> > > solid-state dual-amped speakerbox with a real upper rotor and a
> > > simulated lower rotor run through a static forward facing 12"
> > > speaker. I set it all up, followed the intiial setup and tuning
> > > instructions that came with AMA. I definately hear the added warmth
> > > the AMA introduces, but coudn't get the growl. I played around with
> > > varting the settings on the AMA's pre amp, power amp, and line out
> > > dials, for over an hour, and could not get ot to growl. None, nada,
> > > zip. Any advice?
> > >
> > >
> >
> > [Non-text portions of this message have been removed]
> >
>