From rafael2pop@yahoo.com.ar Sun Jul 27 14:25:20 2008
Subject:Re: Leslie 2101 cabinet rebuild underway -- with photos...

Hey Jason , cool pics of your DIY work !

Nice wood finishing for your VK-8M !

http://launch.ph.groups.yahoo.com/group/CloneWheel/photos/view/1b4f?b=3

I wonder if the woof finishing of the keyboard is cedar or walnut.

Just a personal wish, , would be nice too, to see there the steps of wiring the manual keyboard with a board to get it MIDI-fied.

Lt's say the innards before closing the cabinet at pic#3

Best,

Rafael

Leslie 2101 cabinet rebuild underway -- with photos...
Posted by: "Jason" jblann1@yahoo.com jblann1

Sat Jul 26, 2008 8:26 pm (PDT)

Today I rebuilt my 2101 into a new cabinet, with a few minor changes,
and a major material change. The new cabinet is slightly larger (3/4"
hardwood board instead of the MDF originally built with) but about 10
lbs lighter.

I did not put in side "vents" or louvres, and also did
not angle the 5" drivers on the front side.

This is a keyboard amp more than a traditional leslie, so I've built the cabinet like one.

If I need more juice, I'll mic it and run into a powered cab or to the
house PA.

Pics are up in my photo's page: jblann1's DIY project page

After I stain and finish the cabinet, and install the internals, I'll
videorecord the results and share.

____________________________________________________________________________________
¡Buscá desde tu celular!

Yahoo! oneSEARCH ahora está en Claro

http://ar.mobile.yahoo.com/onesearch