From bruce@ashbysolutions.com Tue Dec 11 17:34:52 2007
Subject:=?ISO-8859-1?Q?Re=3A_=5BCWSG=5D_Re=3A_VB3_Demos_?= =?ISO-8859-1?Q?on_You__Tube=2F_This_thing_is_serious.....?=

Hi,


>> Last, I recently bought an Edirol PCM 800 which just came out. Is
>there a
>> simple way of allowing the nine Edirol sliders to work as a second
>set of
>> drawbars on the lower manual on the XK-1? As it stands, the XK-1
>drawbars
>> control the lower midi manual.
>
>There is a button that switches the drawbars to control both manuals
>and the pedals. If the Edirol can be programmed to send CC #'s 80, 81
>& 82, it can control any of the manuals.

I don't think that this can work without help. Hamm-Suz products send ALL NINE drawbars on one CC#. CC#80 controls the upper manual; CC#81 controls the lower manual; CC#83 controls the pedals. No one else besides Hamm-Suz uses this method. Fairly involved translation is required --

CC#80 0-8 --> Upper 16'
CC#80 9-17 --> Upper 5-1/3'
etc.

I know that a MIDI Solutions Event Processor (or Plus) can do this. Perhaps MidiOx can do something similar. But unless something has changed in the last 4-6 months, Roland/Edirol send one CC# per slider.

Regards,

-BW
--
Bruce Wahler
AshbySolutions.com™
978.386.7389 voice/fax
bruce@ashbysolutions.com

_______________________________________
No viruses found in this outgoing message
Scanned by iolo AntiVirus 1.1.15.10
http://www.iolo.com

[Non-text portions of this message have been removed]