From NJmm973@aol.com Tue May 16 20:04:27 2006
Subject:Re: Stereo clone into mono amp


In a message dated 05/16/2006 9:00:00 P.M. Eastern Daylight Time,
jblann1@yahoo.com writes:

INCREDIBLE in mono if done right) but the key is to run one channel
full frequency range, and the other channel with a significant low
end cut(800hz and below) then mix together.
The result for most clones, should satisfy just about anybody.

What is the best way to achieve this? I currently run the left and right
channels into a Yamaha mixer with 3 equalizer knobs. Would I just turn down
the low end on one channel? Is there a way to know if I'm lowering the
frequencies below 800hz?

Thanks for the detailed advice.

Gene

[Non-text portions of this message have been removed]