From bruce@ashbysolutions.com Thu Jun 08 16:51:02 2006
Subject:Re: b4d expression pedal

Hi All,

>I've seen what you are describing before-- I think you have some of the
>pins mixed up on the 1/4" jack. The FC7 may have Ring or Tip swapped,
>I can't remember but if you have a DVM the Adj should change resistance
>as you move the pedal. Tip to GND should be a constant resistance
>regardless of pedal movement and measure 10-100k ohms

The FC7 is Tip=wiper, Ring=entire pot. Most of the rest of the world swaps these two connections.

Regards,

-BW

--
Bruce Wahler
Design Consultant
Ashby Solutions™ http://consult.ashbysolutions.com
978.386.7389 voice/fax
bruce@ashbysolutions.com

[Non-text portions of this message have been removed]