From bruce@ashbysolutions.com Sat Dec 10 16:31:25 2005
Subject:Re: Where's the map?

Hi,

Yes, that's exactly how Ham-Suz drawbars work under MIDI. 27 drawbars mapped to three CC#'s.

16' @ 0 = 0
16' @ 1 = 1
...
16' @ 8 = 8
8' @ 0 = 9
8' @ 1 = 10
etc.

I don't know if MidiOx can fix it, but the MIDI Solutions Event Processor (or Plus) can fix it.

Regards,

-BW

--
Bruce Wahler
Design Consultant
Ashby Solutions™ http://consult.ashbysolutions.com
978.386.7389 voice/fax
bruce@ashbysolutions.com

At 11:00 PM 12/10/2005 +0000, you wrote:
>Unfortunately, that's what it seemed like. So no individual CC#'s
>for each drawbar?? That would bite.
>
>--- In CloneWheel@yahoogroups.com, "g_e_marshall"
>wrote:
>>
>> Hopefully an XK3 power user will elaborate on this, but to keep you
>> from pulling your hair out, I'd say this...
>>
>> Hammond has always treated the drawbars differently than any other
>> mfg. of clones. While most companies use 1 Midi CC# per drawbar, and
>> divide the 0-127 tics evenly among the 0 possible drawbar settings
>> (0-8), Hammond has used far fewer CC#s, packing all the drawbars in
>a
>> grouping into one CC# (80,81,82 for upper,lower, and pedal
>> respectively) and all the 9 levels of all the drawbars use a chunk
>of
>> the same CC#. See appendix, P. 103 of the owners manual.
>>
>> An outboard midi processor or midi yoke.OX may be able to
>unscramble this?
>>
>> Greg
>>
>> --- In CloneWheel@yahoogroups.com, "almargo_2001"
>wrote:
>> >
>> > Have a quick question.
>> > Trying to change the midi map on my XK-3 so the drawbars,
>leslie,CV and
>> > perc control the B4. Was able to do this very easily with my CX-
>3
>> > several years back, but after trying to navigate the menus and
>owner's
>> > manual for about an hour I still can't make it fly. Any
>suggestions?
>> > I can't seem to drill down into the midi controller number
>> > parameters.
>> >
>> > Thoughts?
>> >
>> > Thanks!
>> > Albert
>> >
>>
>
>To unsubscribe, send email to: CloneWheel-unsubscribe@yahoogroups.com
>Yahoo! Groups Links
>
>

[Non-text portions of this message have been removed]