From Gmarsh4719@aol.com Sat Jan 17 14:25:51 2004
Subject:Re: circuit constants/chops

Moe,

You are right about the 3 main electrical parameters relevant at
DC frequency. But regarding the wires - I presume the wires from the
keyboard bus contacts to the T.G. coils - I have a question...

In reading messages a while back on hammond_zone, I heard something
along the lines that the wire used was resistive by design, and had a
known ohms per inch spec. This may have been for noise reduction or
impedance matching or something, I don't remember. Perhaps my
recollection was about a different set of wires in the hammonds?

I will look back and see. Do you know anything about this?

Greg

> wires.
> > But I could be totally wrong.
> >