From jjmcs49@yahoo.com Sun Dec 26 10:45:07 2004
Subject:Re: Leslie 2101


With the XK-3 connected via the L/M output, the mute switch does not
have much effect on the output. I didn't have the volume turned up
very loud so I don't know if the effect increases as overall volume
increases but when switching to mute it does seem to lower the
volume some from the small tweeters near the top. Also, the small
amount of hiss is stopped. So it seems that it is mute as in
quieter, not as in off. With the 11 pin cable connected (and the XK-
3 set to 2/3 channel Leslie) and the switch set to mute, the brake
button on the XK-3 turns the stationary speakers in the 2101 off
when the brake light and Leslie on lights are both off. When the
switch is not set to mute, the brake and Leslie on buttons both off
lowers the volume from the stationary speakers, but doesn't silence
them.

> any comments regarding the Speakeasy and low frequencies.
>
> --- In CloneWheel@yahoogroups.com, "David Jacques"
> wrote:
> >
> > Right now I have the XK3 running into a Speakeasy then
> > into the 2101 via a 1/4" plug, so I am not using the 11
> > pin cable. Do the XK3 settings that you describe still
> > apply?
> >
> > Also, the three position switch does not seem to turn off
> > the speakers...
> >
> > On Sat, 25 Dec 2004 16:35:40 -0000
> > "jjmcs49" wrote:
> > >
> > > It does sound good doesn't it? There is a small 3
> > >position switch
> > > just below the orange memory button. Just move it all
> > >the way to the
> > > right. Also, make sure that both the Rotary and
> > >Stationary/Bass
> > > outputs are connected to the Mackie amp and set the XK-3
> > >Leslie
> > > setting to a 2 or 3 channel type or create your own
> > >preset. It may
> > > take a little tweaking of the 2101 output volumes to get
> > >the Brake
> > > and non-brake volumes equal.
> > >
> > > Enjoy!
> > >
> > > --- In CloneWheel@yahoogroups.com, "David Jacques"
> > >
> > > wrote:
> > > >
> > > > I just took delivery on a new Leslie 2101 rotating
> > > > speaker, hooked it up to an XK3 and Mackie SRM 450,
> > >and it
> > > > sounds incredible! I will give you all a full report
> > > > after my next gig on New Years Eve...
> > > >
> > > > By the way, anyone know how to turn offthe stationary
> > > > speakers on the 2101? I would hate to blow them out
> > >when I
> > > > reach full volume...
> > >
> > >
> > >
> > > To unsubscribe, send email to:
> > >CloneWheel-unsubscribe@yahoogroups.com
> > >
> > >
> > > Yahoo! Groups Sponsor ADVERTISEMENT
> > >
> > > Yahoo! Groups Links
> > > To visit your group on the web, go to:
> > > http://groups.yahoo.com/group/CloneWheel/
> > > To unsubscribe from this group, send an email to:
> > > CloneWheel-unsubscribe@yahoogroups.com
> > > Your use of Yahoo! Groups is subject to the Yahoo!
> > >Terms of Service.