From dougsloan@neo.rr.com Tue Apr 20 05:09:50 2004
Subject:Re: MidiOx with B4

Hi Claire

You will need to download the companion to MIDI-OX, MIDI Yoke. Pay
attention to your installation, though its not really difficult. MIDI
Yoke allows you to create virtual ports. Then, in your MIDI-OX setup
you'll route your chain allong the lines of:

MIDI Yoke NT: 1(input) - MIDI Yoke NT: 1 (output)

Then on your B4, use the MIDI Yoke NT: 1 as your input, instead of
your MIDI device (i.e. Midiman, etc.)

The key is that you'll need MIDI Yoke. From there, you might have to
read the help section to get the idea, but you'll get what your
looking for. I have a VERY slick midi map for the CX-3 and EVB3.
MIDI-OX in conjunction with MIDI Yolk will allow you to integrate your
software clone as if it were the engine inside your hardware
clone/controller.

Good luck with it and keep us posted as you get it up and running.

Regards,

Doug

>
> Any help would be greatly appreciated. Thank you.
>
> Best regards,
> Claire
> Australia
>
> [Non-text portions of this message have been removed]