From k2mojo@groovedaddies.com Thu Nov 13 11:05:53 2003
Subject:RE: mapping CC's for B4

There may be some info on Deke's site than can help you, like the B4 MIDI
control map.
http://dekethegeek.com/b4/index.asp

Ed Fliege
k2mojo@groovedaddies.com

> -----Original Message-----
> From: funkyhammond [mailto:funkyhammond@yahoo.com]
> Sent: Thursday, November 13, 2003 3:58 AM
> To: CloneWheel@yahoogroups.com
> Subject: [CWSG] mapping CC's for B4
>
> I'm hoping someone can help me out with my setup. I'm trying
> out the B4 program and I'm attempting to use two controllers
> to drive the B4, one programmable, one not. The programmable
> controller is the Edirol PCR-50, and the other one is a Nord
> Electro going into the MIDI IN of the Edirol. I've got the
> Edirol keyboard sending notes for the lower manual (ch 2) and
> controlling everything else with it's sliders/knobs/buttons,
> and the Electro controlling the upper manual (ch 1).
>
> My problem is that all the buttons and knobs on the Electro
> are also sending CC's to the B4, which I don't want. From
> what I can tell, the MIDI settings of the B4 that allow you
> to filter out control changes affect all the channels and
> in-ports; you can't selectively filter only certain channels
> or in-ports, which would have been a solution.
>
> Is there something in the B4 program that I'm overlooking? If
> not, would a software program like MIDI-OX or Bome's Midi
> Translator allow me to remap the CC's of the Electro (which
> would be the Edirol MIDI IN in-port on the PC) to something
> benign or something desirable before they go to the B4? I
> tried playing a bit with MIDI-OX but couldn't figure out if
> it can be used to change the CC's going to the B4 from a
> particular in-port or MIDI channel. I'm using the
> SoundBlaster Audigy card and I do always see "SB Audigy MIDI
> Port" as a selectable in-port and out-port but wasn't sure if
> I had to use this somehow to do a CC mapping and then use the
> SB MIDI Port as the in-port for the B4.