From ynottnaro@yahoo.com Mon Jun 23 17:59:53 2003
Subject:Re: Motion Sound RS 147 heading to the UK., Help still needed please.

I used to own an RS147. I was going to say it weighed
10 lbs, so 11 is definitely correct. Make sure what
you're buying is indeed the rackmounted enclosed
Motion product and not the Pro3t. The RS147 looks
heavier than it is.

T
--- rotosphere2001
wrote:
> Hi Bob,
> Thanks for all that, very helpful.
> The chap I'm buying it from has said it weighs 30
> pounds rather than
> the 11 pounds quoted.
> Obviously this affects the shipping costs.
> However I did see that a Pro3T weighs 27 pounds so
> 30 pounds could be
> correct for the RS.
> Thanks again for your input.
>
> --- In CloneWheel@yahoogroups.com, "Robert Baker"
>
> wrote:
> > Here is some information from
> www.ddrum.ch/motion/r3147.htm. I hope
> it helps. BB
> > Power input: 117 VAC 60 Hz 50 watts
> > Weight: 11 lbs
> >
> > Dimensions: 15" deep x 4 rack units
> high
> > Controls: Pre and post gain with
> clipping indication
> > Crossover: 800 Hz, 12 dB/octave
> > Input Inpedance: 100k
> > Input Level 1: 100 mV rms minimum 300
> mV rms design
> range Unlimited maximum
> > Input Level 2: 250 mV rms minimum 700
> mV rms design
> range Unlimited maximum
> > 1/4" Effects Loop: 350 mV rms
> > Stereo Outputs: 1/4 and XLR .350 volts
> rms
> > Output Impedance: 500 Ohm
> > Signal-to-noise ratio: slow/stop 60dB,
> fast 55 dB
> > Mixer Two microphone pairs -
> close/distantadjustable mix
> > Upper/lower rotor balance control
> > Features: 12AX7A Tube Preamp
> > Front Panel Pro-3 or type 147 tone
> control (10kHz -
> 4kHz)
> > 40 watt FET power amp, .02% distorsion
> > Superlife, zero maintenance poly
> propelene belt.
> > Quiet DC servo controlled horn motor
> > Zero maintenance horn ball bearings
> Rear accessory
> output connector
> > Speed control - fast, slow, stop or
> variable with Gas
> Pedal
> > Fast speed indicator
> > Convenient front panel connector with
> foot witch Midi 16
> channel selectable with stop and disable
> >
> > Weight: 11 lbs
> >
> >
> >
> >
> >
> > ----- Original Message -----
> > From: rotosphere2001
> > To: CloneWheel@yahoogroups.com
> > Sent: Monday, June 23, 2003 1:16 PM
> > Subject: [CWSG] Motion Sound RS 147 heading to
> the UK., Help
> needed please.
> >
> > Hi all,
> > Three questions regarding the RS 147 please.
> > 1. What is its weight?
> >
> > 2. What mains wattage does it draw? I've bought
> a USA/UK
> stepdown
> > transformer for use up to 100Vac to 120Vac with
> maximum current
> draw
> > of 100 watts. As the RS is basically a Pro 3T
> with a different
> set of
> > clothes, I would think that it would draw the
> same current as a
> Pro
> > 3T., so a Pro 3T owner could help with this
> question.
> >
> > 3. What do regular USA mains plugs look like. Is
> there just one
> > regular type of mains plug used in the USA? The
> moulded socket on
> the
> > transformer ( where the RS will plug into ) is a
> small three pin
> > socket, 1"x1" with two oblong sockets at the
> bottom, the right-
> hand
> > one being slightly longer than the left, and the
> top socket
> (forming
> > a triangle with the two lower sockets ) is
> shaped roughly like a
> > sheild, flat at the top and curved at the
> bottom.
> >
> > Thanks for any info.
> > Thomas. ( UK )
> >
> > Yahoo! Groups Sponsor
> >
> >
> > To unsubscribe, send email to: CloneWheel-
> unsubscribe@yahoogroups.com
> >
> > Your use of Yahoo! Groups is subject to the
> Yahoo! Terms of
> Service.
> >
> > [Non-text portions of this message have been
> removed]
>

__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com