From bruce@brucemattson.com Mon Jul 07 19:00:43 2003
Subject:RE: cx-3 rotary control
using a latching switch…
I don’t think so. The similar experience that I described having with my
BX3 in an earlier response occurred first with an Alesis Q series KB damper
switch pedal, then again with some generic piece I had on hand, both of
which were dampers, - momentary by design. My Kurzweil and Korg dampers, on
the other hand, worked correctly right away for Leslie switching.
I experienced the same phenomenon described by masiegel49 - I had to tap
twice to get the speed to change, then twice again to change back.
Baffled me too, because I’d never come across that behavior before.
Bruce Mattson
-----Original Message-----
From: Randal Muir [mailto:randal.muir@bigpond.com]
Sent: Monday, July 07, 2003 8:39 PM
To: CloneWheel@yahoogroups.com
Subject: Re: [CWSG] cx-3 rotary control
It sounds to me that you are using a latching switch and should be using a
momentary on or off (depending on required polarity). A damper pedal of the
correct polarity should do it.
cheers -Randal
----- Original Message -----
From: masiegel49
To: CloneWheel@yahoogroups.com
Sent: Monday, July 07, 2003 5:29 PM
Subject: [CWSG] cx-3 rotary control
I must be missing something, but I've tried to use a foot switch to
control the
rotary on my cx-3 using the assignable input with puzzling results. The
switch
must be clicked twice to change the rotary from slow to fast, and vice
versa.
I'm using a roland switch, so could that be the problem? Any suggestions?
Yahoo! Groups Sponsor
To unsubscribe, send email to: CloneWheel-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]
Yahoo! Groups Sponsor
59:HM/A=1524963/R=0/SIG=12o72ctft/*http:/hits.411web.com/cgi-bin/autoredir?c
amp=556&lineid=3512844∝=egroupweb&pos=HM>
l/S=:HM/A=1524963/rand=323099034>
To unsubscribe, send email to: CloneWheel-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo!
Terms of Service.
[Non-text portions of this message have been removed]