From john.fisher@m.cc.utah.edu Fri Feb 14 12:05:25 2003
Subject:Re: Question for V5 users (was Re: V5 expression)

FYI Be aware that many Keyboard amps and mixers have input impedances of 50K
and less. Most Ernie Ball pedals have 250K audio taper pots that rarely are
adjusted to go "full on" leaving significant resistance to attenuate the
signal. (Motion Sound products are 50K or 100K input impedance). We often
receive calls from users that can not get enough gain to overdrive the tube
which is due to the loss in there analog pedal. Some people have replaced
the 250KA pot with a 5KA pot which then works fine as a volume control.

John Fisher

John Fisher
>
> Regards,
> Eric Lawson
> Moderator
> CloneWheel Support Group
> http://groups.yahoo.com/group/CloneWheel/
> -----Original Message-----
> From: Stoo Schultz
> [mailto:schultz@fig.cox.miami.edu]
> Sent: Friday, February 14, 2003 12:52 PM
> To: CloneWheel@yahoogroups.com
> Subject: [CWSG] Question for V5 users (was Re: V5 expression)
>
> --- In CloneWheel@yahoogroups.com, Eric Lawson wrote:
> > I used a V5 for quite some time and liked it a lot. For
> expression, I used
> > an Ernie Ball volume pedal and it worked like a champ!
>
> Now I'm confused . . . isn't that a volume pedal, not an expression
> pedal?
>
> To unsubscribe, send email to: CloneWheel-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
>
> [Non-text portions of this message have been removed]
>
> To unsubscribe, send email to: CloneWheel-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>