From goff747@aol.com Thu Dec 25 20:52:27 2003
Subject:Re: Photos of my Clone Rig posted in the "Photos" section


In a message dated 12/26/03 12:00:17 PM, obxwindsurf@yahoo.com writes:

<< The "drawbar module" is a nearly full featured B4 control surface.

It uses a set of modified M3 drawbars from a Hammond, 3 rotary

switches, and a handful of toggle switches, in addition to a real

half moon to control most of what you see in the Console View of the

B4. I built a processor board from a Basic Stamp 2sx

microcontroller and a handful of interface chips (decoders, priority

encoder and some gates to implement bus arbitration.

Regards,

Kevin >>

genius out of the woodwork.... kudos !