From flyer42@aol.com Wed Jan 02 14:21:05 2002
Subject:Re: A related? Leslie Question

In a message dated 1/2/2002 2:47:44 PM Eastern Standard Time,
las8323@rs175174.ks.boeing.com writes:

> Now, I don't wanna cheat BobSchl out of a sale, but there just HAS to be
> a quick easy way to solder up one of these yourself for waaaaaay less than
> the $149 or so -- if you're so inclined to solder, that is.
>
> Anyone have an idea about this?
> Larry
>

Hi, I made a solid state switching box out of an old power relay panel from
an old Data General 6026 tape drive. The small module has 2 solid state
relays on it, and a low current 12 volt supply, and already has the A/C jack
on it. Since I don't use the original Leslie amp, all I had to do was swap a
couple of wires around, wire it to the leslie motors and put a footswitch
jack on it. I also put it in a metal box.

Steve Randall

[Non-text portions of this message have been removed]