From eslawson@juno.com Sun Aug 04 20:19:46 2002
Subject:Re: Can the CX-3 send sustain to a module?

Bruce,

You're brilliant!!! Thank you! I just tried these instructions and
I was able to get it to work. I missed that "Hold" page altogether.
I had all my CC TX and RX disabled, mainly due to the fact that I am
always MIDI-ing my CX3 to itself to bypass the double-flam defect.
It's still a little bit klugey to get it all working properly given
the fact that I have a MIDI merge box in the chain with the JV1010
being in the middle of things.

Now one set of the drawbars is sending strange CCs to the JV1010 to
edit the ADSRs and stuff like that. Another night I will need to go
in and disable that stuff, if possible.

Thanks again for the tip...that helped a lot.

Regards,
Eric

> It's sort of in three parts:
>
> 1. On page 20, there are settings for Hold Upper Ctrl and Hold
Lower Ctrl, which can be set for Pedal 1 or 2, on a per-patch basis.
>
> 2. On page 23, there is a global setting called MIDI Tx C. Change,
which must be set to Enable, so that the controller messages go out
the MIDI Out jack.
>
> 3. On page 25, there is a global setting called CC# Hold, which
should be set to the CC# your JV1010 uses for sustain, which is
probably CC#64.
>