From bruce@ashbysolutions.com Wed Jun 20 09:08:18 2001
Subject:Re: Need your help guys, CX-3 & KBR-3d

Howard,

>I have read and reread the Korg manual to find out how to make two
>separate sets of 32 patches so I can have one set with the CX-3
>rotary turned off for use with my motion sound kbr-3d and the other
>with it as shipped so I can use my headphones and the internal rotary
>sound.

The manual doesn't tell you anything about it; it's just a trick I
use. There are two ways to do it, either one can be considered either
painful, or a no-brainer, depending on how you think when converting one
sound to another:

1. Store up to 32 patches in Bank A - Bank D. Make sure all of
them are either Leslie-sim-on or Leslie-sim-off; it doesn't
matter which.

2a. Copy the patches to Bank E - Bank H. Enter Edit mode and
change the Amp Type, Amp Gain, EQ, and Leslie sim on/off
settings as needed, and rename the patch. I usually choose
to put a character at the end to show which bank has the
simulator.

or:

2b. Copy patch A1 to location E1. Change the settings as in 2a,
and rename the patch. Then copy this new patch E1 to E2, E3,
... H7, H8 (if you need that many). Then enter each of
those patches and change the drawbars, percussion, etc. and
rename them.

Either way, in the end you will have something like this:

Leslie Patches Simulator Patches

A1 Jimmy Smith E1 Jimmy Smth S
A2 Rock Solo E2 Rock Solo S
A3 Gospel Choir E3 Gospel Chr S
... ...
D7 Deep Purple H7 Deep Purpl S
D8 EL&P H8 EL&P S

I hope this helps.

Regards,

-BW

--
Bruce Wahler
Design Consultant
Ashby Solutions"
www.ashbysolutions.com
CloneWheel Support Group moderator
978.386.7389 voice
978.964.0547 fax
bruce@ashbysolutions.com

At 03:37 p 6/20/2001 +0000, you wrote:
>gadgets. Rather than post to everyone and waste bandwith feel free to
>privately e-mail me at hpage@thepipeline.net thanks Howard.
>
>Yahoo! Groups Sponsor
>10d3b9f.jpg