From bruce@ashbysolutions.com Sun Aug 26 15:43:02 2001
Subject:Re: Updating your CX-3

Renee,

> > By the way, does your M/S display also only stay for 1/4 second?
>
>No, it stays until I select another preset.

That's certainly different than my results. I only tried to program it
once. (I ran out of time.) When I can get it back, I will experiment
around a bit on it.

I have no idea why your system stopped at S111400. Possible candidates
are: a) I was mistaken, and my CX-3 is still at S111400, too; and b)
certain revisions of the hardware can only take certain revisions of firmware.

At any rate, I used M111500/S111400 for five months, with no issues
seen. S111400 is certainly much better than what you had.

Regards,

-BW

--
Bruce Wahler
Design Consultant
Ashby Solutions™
www.ashbysolutions.com
CloneWheel Support Group moderator
978.386.7389 voice
978.964.0547 fax
bruce@ashbysolutions.com